Product FAQs
CCD sensors, create high-quality, low-noise images. CMOS sensors, traditionally are more susceptible to noise. Because each pixel on a CMOS sensor has several transistors located next to it, the light sensitivity of a CMOS chip tends to be lower. Many of the photons hitting the chip hit the transistors instead of the photodiode. CMOS traditionally consumes little power. Implementing a sensor in CMOS yields a low-power sensor. CCDs use a process that consumes a lot of power. CCDs consume as much as 100 times more power than an equivalent CMOS sensor. CMOS chips can be fabricated on just about any standard silicon production line, so they tend to be extremely inexpensive compared to CCD sensors. CCD sensors have been mass produced for a longer period of time, so they are more mature. They tend to have higher quality and more pixels.
Temperature range for most cameras is from -4œF to 122œF.
This camera has BNC female for video and a female power connector.
This camera can be run from as far as 300 ft. when using 60 ft or 120 ft extension cables. With one single RG59 cable, this camera can extend up to 1000 ft.
A fixed focal length lens cannot zoom. The focus is fixed. A fixed focal length lens usually allows more light to pass through the lens at a given focal length than a varifocal, or zoom lens. This can be important in low light situations.
The cameras themselves do not record. In order to record motion you need a motion detection DVR. When power is supplied the cameras will continually send video feed through an RCA cable (wired) or through the air (wireless).
Resolution refers to the cameras ability to reproduce images. The higher the resolution, the better. Lux refers to the amount of light that is needed for the camera to see. This becomes important if you need the cameras to see in low light. The lower the Lux, the better.
Cameras have a working temperature range in between 14œF to 130œF. If the temperature falls below the minimum for a long period of time, it would damage the camera. The best solution for this is putting the camera in a Heater/Blower Housing Unit.
